Octopus
DY5001
Tam Valley - 5V Remote DPDT Relay Board w/Y
A DPDT relay for using on a Y cable in conjunction with a fascia controller. (Will also work without the fascia controller.) Has a 6-pin connector block to simplify wiring.
more info on 5V Remote DPDT Relay Board w/Y...This item is in Stock and available for dispatch
£15.00
OCD001
Tam Valley - Octocoder DCC Add-on Decoder
By adding this DCC stationary/accessory decoder to the Octopus you can control your turnouts with servos and DCC at the lowest possible cost per turnout. No frills just throws the turnouts from your throttle or JMRI.
more info on Octocoder DCC Add-on Decoder...Only 1 remaining in stock
£20.50
OCT030
Tam Valley - Octopus III Servo Driver
Octopus III Eight Servo Driver
The Octopus III can drive up to 8 servos to move turnouts or other devices on your layout controlled by a toggle switch, a momentary push button, the output of a signal system or a DCC decoder. There are 8 positions for... more ...
more info on Octopus III Servo Driver...This item is in Stock and available for dispatch
£41.00
OCT031
Tam Valley - Remote Aligner for Octopus III
Used with the Octopus III for alignment of servos (cannot be used with the Octopus II). Just one of these needed for all of your Octopus IIIs. Comes with a 7' cable which allows you to stand next to your turnout while aligning the servo.
more info on Remote Aligner for Octopus III...This item is in Stock and available for dispatch
£13.20