Feedback
rcr
DCC4PC - Rail Comm Reader
The 16 Zone Local RailCom™ Reader Device
Our RailCom™ Reader device, unlike some others on the market, can cope with more than one RailCom™ enabled locomotive in a single zone, and it can distinguish between Short addresses, Long addresses and... more ...
more info on Rail Comm Reader...This item appears to not currently be in stock
But is still available to order
£160.42
15120
Lenz - LRC120 RailCom Address display
This 4-digit display serves to depict the address of the locomotive located in a monitored track section. Installation is possible anywhere on the layout, for example inside a signal box.
more info on LRC120 RailCom Address display...This item appears to not currently be in stock
This item is on back order with our suppliers
Our Price
£53.96
Lenz - LW150 Mimic panel module
Construct a mimic panel for your layout using the LW150.
16 accessory addresses may be controlled (Points and signals).
32 LEDs can also be powered to show the position of the 16 accessories.
Use either Push to Make or $32108-Centre... more ...
more info on LW150 Mimic panel module...This item is in Stock and available for dispatch
Our Price
£92.70
BOD-8-SM
RR-CirKits - Block Occupancy Detector
This board is compatible with LCC node sample mode which allows using output drivers on the same I/O port. This board operates as a DCC occupancy detector for 8 blocks using remote CT coils (not included). It outputs logic levels, and has a... more ...
more info on Block Occupancy Detector...This item is in Stock and available for dispatch
£51.00
WatchMan
RR-CirKits - WatchMan
Includes 8 detector amplifiers for DCC current Detection. Coils not included.
Detection levels adjustable from 1⁄2 ma to 20 ma DCC. (20K ohm or less)
Train current maximum of 10A or... more ...
more info on WatchMan...This item is in Stock and available for dispatch
£45.85
Cab-Bus
Feedback units that are compatible with NCEs Cab-Bus System
524-200
NCE - AIU01 Aux. Input unit
The Auxiliary Input Unit provides connection of block occupancy detectors, switch position relays, etc. for purposes of signaling and/or computer control of your layout.
more info on AIU01 Aux. Input unit...This item is in Stock and available for dispatch
£52.50
Cabling
000101
Littfinski DatenTechnik - Cable s88 2m
Extension cable for connection of s88 feedback modules; twisted and interference protected. Including 2 original s88-plugs. Length 2m.
more info on Cable s88 2m...This item is in Stock and available for dispatch
£15.55
Detection Units
Independent detection units for use as stand-alone or connection back into another Feedback
DCP-MSiA.3
DCC Concepts - Slim Vertical Mounted Magnetic Sensors
These detectors have been designed to be very easy to install. Only 4mm in diameter, they will fit between the sleepers of Peco Code 100 and Code 75 track.
They are “Normally Off” and are triggered by a small magnet that is attached to the loco or... more ...
more info on Slim Vertical Mounted Magnetic Sensors...This item is in Stock and available for dispatch
Our Price
£11.00
DCP-MSiA.6
DCC Concepts - Slim Vertical Mounted Magnetic Sensors - 6pk
These detectors have been designed to be very easy to install. Only 4mm in diameter, they will fit between the sleepers of Peco Code 100 and Code 75 track.
They are “Normally Off” and are triggered by a small magnet that is attached to the loco or... more ...
more info on Slim Vertical Mounted Magnetic Sensors - 6pk...This item is in Stock and available for dispatch
Our Price
£21.22
DCC Concepts - Intelligent Detector (Single Pack)
Legacy Models Intelligent Detector Single Pack (LM-iD.1)
The Legacy LM-iD is an intelligent Inductive detector that is easy to install, trouble free and exceptionally reliable.
Available as a pack of 3
LM-iD works everywhere: On... more ...
more info on Intelligent Detector (Single Pack)...This item is in Stock and available for dispatch
Our Price
£16.10
Page (1) of (5)